CCT Practice Test 9 – Free Tech Exams

What commands would you use to view the licenses installed on the Cisco device? (Choose two.)

A. show license

B. show info

C. show device details

D. show version

E. show software

Which of the following devices filters traffic by sending the data only to the port that the destination MAC address is connected to?

A. Switch

B. Router

C. Access point

D. Firewall

What type of transceiver module is displayed in the exhibit?

A. GBIC

B. HWIC

C. SFP

D. Flash memory

Which of the following shows correct mapping of device and OSI model?

A. Layer 1->Router, Layer 2->Hub, Layer 3- >Switch

B. Layer 1->Switch, Layer 2->Hub, Layer 3- >Router

C. Layer 1->Hub, Layer 2->Router, Layer 3- >Switch

D. Layer 1->Hub, Layer 2->Switch, Layer 3- >Router

Looking at the exhibit, what is the model of the Cisco device?

A. 00:1C:57:CF:64:80

B. FD01125Z6VQ

C. Layer 2

D. WS-C3750G-24TS-S

You have a Gigabit interface on the switch that displays the status “GigabitEthernet0/0 is up, line protocol is down.” What could be a reason for this? (Choose two.)

A. Speed mismatch

B. Incorrect IP address

C. Invalid subnet mask

D. Cable not connected

E. Duplex mismatch

What port on a Cisco device is used for remote administration purposes?

A. AUX

B. Console

C. USB

D. Flash

You are performing a password recovery on your Cisco device. You have rebooted the device and bypassed applying the startup config to your device. What command would you run after rebooting?

A. write

B. copy startup-config running-config

C. write erase

D. copy running-config startup-config

Which Cisco switch operation mode retrieves a Cisco IOS image from flash memory and then loads it into RAM on bootup?

A. Global mode

B. Bundle mode

C. Privilege mode

D. Install mode

While performing some routine maintenance on the router, you use a command that generated the output shown in the exhibit. What command did you use?

A. show version

B. show inventory

C. show interfaces

D. show ip interface brief