CCT Practice Test 6 – Free Tech Exams

What command was used to generate the output shown in the exhibit?

A. show interfaces

B. show ip interface brief

C. show inventory

D. show version

What type of connector(s) is on the HWIC 2A/S module that is installed in your Cisco router?

A. Single RJ-45 connector

B. Two RJ-45 connectors

C. Two v.35 serial connectors

D. Single LC connector

You are currently at the interface prompt. What command would you use to navigate back to Global Configuration mode?

A. back

B. exit

C. end

D. return

Which of the following is a valid IPv4 address that can be assigned to a system on the network?

A. 0.0.0.0

B. 191.287.56.22

C. 255.255.255.255

D. 145.34.87.10

You are creating a loopback plug for your T1 port. Which of the following pins would you connect together in the loopback plug? (Choose two.)

A. Connect pin 1 to pin 4.

B. Connect pin 2 to pin 6.

C. Connect pin 2 to pin 5.

D. Connect pin 3 to pin 6.

E. Connect pin 1 to pin 7.

What commands would you use to change the configuration register? (Choose two.)

A. rommon>config-register 0x2102

B. rommon>confreg 0x2142

C. router>config-register 0x2102

D. router(config)#confreg 0x2102

E. router(config)#config-register 0x2102

Which Cisco switch operation mode uses the package-provisioning filename packages.conf to boot the switch?

A. Install mode

B. User EXEC mode

C. Bundle mode

D. Priv EXEC mode

Which of the following is a Gigabit Ethernet standard that uses multimode fiber-optic cabling?

A. 1000BaseT

B. 1000BaseSX

C. 1000BaseCX

D. 1000BaseLX

Select the three correct mappings of the prompt to the mode that the prompt refers to.

A. router> ==> priv EXEC, router# ==> user EXEC, router (config)# ==> Global Configuration

B. router> ==> user EXEC, router# ==> priv EXEC, router (config)# ==> Global Configuration

C. router> ==> user EXEC, router# ==> Global Configuration, router (config)# ==> priv EXEC

D. router> ==> Global Configuration, router# ==> user EXEC, router (config)# ==> priv EXEC

What type of network device is needed to send data off the network?

A. Switch

B. Router

C. Hub

D. Server