CCT Practice Test 4 – Free Tech Exams

What command in Windows would you use to launch a command prompt on your laptop?

A. terminal

B. com

C. notepad

D. cmd

What command would you use to specify to the Cisco device which IOS image it is to load from flash memory when booting?

A. init flash

B. flash system

C. boot flash

D. boot system

You want to remote securely into a device to modify its configuration. What command would you use?

A. ssh

B. telnet

C. ping

D. traceroute

You want to change the duplex setting on an interface. What command would you use?

A. full duplex

B. enable duplex full

C. duplex full

D. enable duplex half

Which of the following scenarios would require the use of a straight-through cable? (Choose two.)

A. Computer to computer

B. Computer to switch

C. Switch to switch

D. Computer to router

E. Switch to router

Which of the following is a valid IPv6 address?

A. 2001::ad66:8620::9601

B. 2001::ad66:8620:c5f9:9601

C. ::

D. 2001::ad66:8G20:c5f9:9T01

You are a technician who is troubleshooting connectivity problems on a Windows system. What command would you use to view the IP address settings on a laptop running Linux?

A. ifconfig

B. ping

C. ipconfig

D. traceroute

Look at the exhibit. Why are you unable to communicate on the LAN using the Gigabit Ethernet interface?

A. No IP address is assigned.

B. There is a speed mismatch.

C. The interface has been disabled.

D. There is a duplex mismatch

What type of memory on a Cisco device stores the Cisco IOS?

A. ROM

B. NVRAM

C. RAM

D. Flash

You want to console into the router using a USB cable. What type of connector would you use to connect to the USB console port?

A. USB mini-B (5-pin)

B. USB Type A

C. USB mini-B (4-pin)

D. USB Type B