CCT Practice Test 2 – Free Tech Exams

You are connecting your laptop to the network to perform some connectivity tests. What type of cable should you use to connect your laptop to a port on the switch?

A. Crossover

B. Rollover

C. Straight through

D. USB

What command would you use on your router to configure the internal Gigabit Ethernet port to receive an IP address automatically?

A. Router(config)#ip address dhcp

B. Router(config-if)#ip address dhcp

C. Router#ip address 0.0.0.0 255.255.255.255

D. Router(config-if)#ip address 0.0.0.0 255.255.255.255

You have changed the IP address of the Gigabit Ethernet interface on your router. Where is the configuration change stored on the device?

A. NVRAM

B. Flash

C. RAM

D. ROM

You have telnetted into your switch from your router. What command would you use to suspend the telnet session?

A. CTRL-BREAK

B. SHIFT-6

C. CTRL-SHIFT-B

D. CTRL-SHIFT-6, X

You need to change your laptop to use a static IP address. Which of the following best represents the steps required to do this?

A. Control Panel -> Network and Internet -> Network and Sharing -> Change Adapter Settings -> Right- click Ethernet and choose Properties -> Select Internet Protocol Version 4 -> Properties -> Obtain an IP address automatically

B. Control Panel -> Network and Internet -> Network and Sharing -> Change Adapter Settings -> Right- click Ethernet and choose Properties -> Select Internet Protocol Version 4 -> Properties -> Use the following IP address

C. Control Panel -> System and Security -> Change Adapter Settings -> Right-click Ethernet and choose Properties -> Select Internet Protocol Version 4 -> Properties -> Obtain an IP address automatically

D. Control Panel -> System and Security -> Change Adapter Settings -> Right-click Ethernet and choose Properties -> Select Internet Protocol Version 4 -> Properties -> Use the following IP address

Your manager is concerned about the security risks involved with using telnet as a remote administration protocol to your company routers and switches. Which of the following would you present as a solution ?

A. HTTP

B. FTP

C. SSH

D. TFTP

Which bits in the configuration register correspond to the boot field bits?

A. The upper 4 bits

B. The lower 4 bits

C. The middle 4 bits

D. The middle 2 bits

You have subscribed to a T1 connection with your service provider to get access to the WAN environment. What component is needed to connect your router to the T1 link?

A. WLC

B. Crossover cable

C. Access point

D. CSU/DSU

Which of the following IPv6 address is a link-local address?

A. 2001::ad66:8620:c5f9:9601

B. fec0::ad66:8620:c5f9:9601

C. ::1

D. fe80::ad66:8620:c5f9:9601

What command would you use to initiate the System Configuration Dialog?

A. boot system

B. config term

C. init

D. setup